TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
13. Using digital multimeter
Kickout System Will Not
Continuity at Either Test Point
(WP 0174), test for continuity at
Operate or Operates
Replace lower cab wiring harness
connector C-C9 (WP 0012,
Improperly - Continued
(WP 0291).
Figure 153) as follows:
Proceed to Test Step 60.
a. between terminal 6 and all
No Continuity at Either Test Point
other terminals in connector
Proceed to Test Step 33.
C-C9.
b. Between terminal 6 and
ground.
Test Step 33. Test for Shorted Carry
Kickout Position Sensor.
1. Connect connector LE-C5
(WP 0012, Figure 237) to
connector N-C1 (WP 0012,
Figure 238).
2. Connect connector LE-C2
(WP 0012, Figure 152) to
connector C-C9 (WP 00122,
Figure 153).
3. Connect connector LE-C1
(WP 0012, Figure 87) to connector
C-C10 (WP 0012, Figure 86).
4. Connect connector C-C6
(WP 0012, Figure 70) to
implement disable switch
(WP 0012, Figure 71).
5. Connect connector C-C37
(WP 0012, Figure 241) to kickout
switch (WP 0012, Figure 242).
6. Connect connector C-C38
(WP 0012, Figure 239) to bucket/
fork switch (WP 0012, Figure 240).
7. Connect connector LE-C18 to
carry kickout position sensor
(WP 0012, Figure 236).
8. Set implement disable switch to
unlock position
(TM 5-3805-298-10).
9. Set kickout switch to ON position
(TM 5-3805-298-10).
10. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
0155-39
