TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Turn ignition switch and battery
Kickout System Will Not
disconnect switch to OFF position
Operate or Operates
(TM 5-3805-298-10).
Improperly - Continued
5. Remove kickout fuse
(TM 5-3805-298-10).
6. Using digital multimeter
Resistance 5.0 Ohms or Less -
Replace pilot valve (WP 0379).
(WP 0174), measure resistance
between kickout fuse terminals.
Install kickout fuse
(TM 5-3805-298-10).
Proceed to Test Step 60.
Resistance Greater Than 5.0 Ohms -
Replace fork kickout position sensor
(WP 0297).
Replace kickout fuse
(TM 5-3805-298-10).
Proceed to Test Step 60.
Test Step 37. Test for Shorted Lower
Cab Wiring Harness.
1. Remove console instrument panel
for access to wiring harness
connectors (WP 0264).
2. Disconnect connector C-C6
(WP 0012, Figure 70) from
implement disable switch
(WP 0012, Figure 71).
3. Remove right lower cab access
panel (WP 0347).
4. Disconnect connector EN-C2
(WP 0012, Figure 12) from
connector C-C18 (WP 0012,
Figure 13).
5. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C18
Replace kickout fuse
terminal 10 (WP 0012, Figure 13)
(TM 5-3805-298-10).
and ground.
Proceed to Test Step 60.
No Continuity - Proceed to Test
Step 38.
0155-44