TM 5-3805-298-23-2
0166
STEERING WHEEL TIME CHECK CONTINUED
24. The normal cycle time from stop to stop in either direction in high idle (2,450 rpm) is 1.5 to 1.8 seconds.
25. With the parking brake engaged the cycle times should not increase by more than 0.2 seconds.
26. The difference between turning right to the stop and turning left to the stop should not be more than
0.3 seconds.
END OF TASK
AIR PURGE ON IMPLEMENT HYDRAULIC SYSTEM
000166
WARNING
DO NOT disconnect or remove any hydraulic system line or fitting unless engine is shut
down and hydraulic system pressure has been relieved. Tighten all connections before
applying pressure. Escaping hydraulic fluid under pressure can penetrate the skin,
causing injury to personnel.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
To prevent injury to personnel, wear protective eye covering and gloves.
Sudden movement of machine can cause injury to personnel on or near the machine.
Failure to follow these warnings may result in injury to personnel.
CAUTION
When servicing this machine, performing maintenance, or disposing of hazardous
materials, consult your unit/local hazardous waste disposal center or safety office for local
regulatory guidance. If further information is needed, please contact the Army
Environmental Hotline at 1-800-327-3845.
Do not perform this procedure unless directed here from troubleshooting or a repair
procedure. Failure to follow this caution may result in an improper diagnosis.
0166-21
