TM 5-3805-298-23-2
0174
MILITARY CONNECTOR REPAIR
000174
1. Slide shell (Figure 12, Item 1) backward on wire (Figure 12, Item 2) to expose sleeve (Figure 12,
Item 5).
2. Remove sleeve (Figure 12, Item 5) from terminal (Figure 12, Item 4) by pulling sleeve forward.
3. If defective, remove terminal (Figure 12, Item 4) from wire (Figure 12, Item 2) by cutting through wire just
behind terminal.
NOTE
Perform steps 4 through 6 only if terminal was removed.
4. Using wire stripping tool, strip insulation from wire (Figure 12, Item 2) to expose length of metal strands
(Figure 12, Item 3) equal to depth of terminal (Figure 12, Item 4).
5. Using crimping tool, securely crimp terminal (Figure 12, Item 4) to metal strands (Figure 12, Item 3) of wire
(Figure 12, Item 2).
6. Install sleeve (Figure 12, Item 5) on terminal (Figure 12, Item 4) by pushing sleeve over front of terminal until
fully seated.
7. Slide shell (Figure 12, Item 1) up wire (Figure 12, Item 2) and over sleeve (Figure 12, Item 5).
Figure 12. Military Connector Repair.
0174
END OF TASK