TM 5-3805-298-23-2
0182
REMOVAL CONTINUED
2. Remove damper (Figure 2, Item 4) and pulley (Figure 2, Item 3) from hub (Figure 2, Item 1).
3. Remove three bolts (Figure 2, Item 5), block (Figure 2, Item 2), and hub (Figure 2, Item 1) from machine.
Figure 2. Damper and Crankshaft Pulley.
0182
END OF TASK
CLEANING AND INSPECTION
000182
Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0172).
END OF TASK
INSTALLATION
000182
NOTE
Prevent crankshaft from rotating while tightening hub bolts.
1. With assistance and using chain pipe wrench, install hub (Figure 2, Item 1), block (Figure 2, Item 2), and three
bolts (Figure 2, Item 5) on machine. Tighten bolts to 147 lb-ft (200 Nm).
2. Install crankshaft pulley (Figure 2, Item 3) and crankshaft damper (Figure 2, Item 4) on hub (Figure 2, Item 1).
