TM 5-3805-258-24-2ENGINEDISASSEMBLY AND ASSEMBLYINSTALL CAMSHAFT1.2.3Put clean engine oil on the bearing journals and2P2506 Thread Lubricant on the cam lobes ofthe camshaft. Install a 3/8”-16 NC forged eye-bolt in the camshaft. Use the eyebolt and acrow foot bar to hold camshaft (1) up duringinstallation so the camshaft bearings will not bedamaged.CAMSHAFT1210-12Install thrust plate (2), the lock and bolts thathold the camshaft in place. Turn the camshaftso the notch in the end of the camshaft is in theposition shown.Put camshaft gear (3) in position on the cam-shaft so the “C” mark on the camshaft gear isin alignment with the “C” mark on the crank-shaft gear. Install the bolts that hold the cam-shaft gear in place and tighten to a torque of 55± 7 N·m (41 ± 5 lb. ft.).NOTE: If the bolts can not be installed in the end ofthe camshaft, remove the camshaft gear. Turn thecamshaft as needed and install the camshaft gearagain. Check the engine timing to make sure thetiming is correct. See INSTALL FUEL INJEC-TION PUMP HOUSING AND GOVERNOR.end by:a) install timing gear coverb) install valve lifters5-138
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
