OPERATOR’S STATION
BLACKOUT LIGHTING
REMOVE LIGHTING CONTROL SWITCH
1.
2.
3.
4.
Remove two nuts and washers that secure
panel (1) to the vehicle cab. Panel is located
on the left side of the driver’s seat.
Disconnect wiring harness cable (2) from the
lighting control switch (3).
Remove screws (4) and levers (5).
Remove four screws (6) and washers (7) that
secure switch (3) to panel (1).
INSTALL LIGHTING CONTROL SWITCH
1. Secure lighting control switch (3) to panel (1)
with four screws (6) and washers (7).
2. Secure levers (5) with screws (4).
3. Connect wiring harness cable (2) to the
switch.
TM 5-3805-258-24-2
DISASSEMBLY AND ASSEMBLY
4. Secure panel (1) to vehicle cab with two nuts
and washers.
REMOVE BLACKOUT LAMP ASSEMBLY
1. Disconnect wiring (1) from the back of the
blackout light (2).
2. Remove nut (3), lockwasher (4), and blackout
light (2).
INSTALL BLACKOUT LAMP ASSEMBLY
1. Secure blackout light (2) with lockwasher
(4) and nut (3).
2. Connect wiring (1) to the back of the light.
5-500a
