TM 5-3805-262-20
3-33. STARTING SYSTEM TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. STARTER CRANKS SLOWLY (UNDER 200 RPM).
Step 1.
Open radiator grille at rear of loader.
Connect STE/ICE power cable W5 connector P1 to VTM J1.
Check that VTM PUSH ON/PULL OFF switch is in OFF position.
Connect power cable W5 red clip lead to loader battery positive post
and black clip lead to loader battery negative post.
Remove engine left side panels (page 9-14).
Loosen and disconnect tachometer cable nut from tachometer drive.
Install STE/ICE pulse tachometer in loader tachometer drive.
Connect transducer cable W4 connector P1 to VTM J3.
Connect transducer cable W4 connector P2 to pulse tachometer.
Do STE/ICE confidence test (TM 9-4910-571-12&P).
Dial 60 into TEST SELECT and press and release TEST button.
When UEH appears on display, dial 22 into TEST SELECT.
Press and release TEST button.
Check that VTM displays 22. If 22 is not displayed, STE/ICE is de-
fective (refer to TM 9-4910-571-12&P).
Connect transducer cable W4 connector P1 to VTM J2.
Connect transducer cable W4 connector P2 to current probe (TK item
11).
Clamp current probe around battery positive cable with current probe
arrow pointing away from battery. Be sure current probe is closed.
Dial 10 into VTM TEST SELECT and press and release TEST button.
Shut off fuel by pulling fuel SHUT OFF control out.
3-274
