TM 5-3805-262-20
3-33. STARTING SYSTEM TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. STARTER CRANKS CONTINUOUSLY (Cont).
Step 2.
Move red test clip of test probe cable W2 to starter relay terminal
to which violet-black wire is connected (second terminal from left).
Move black test clip of test probe cable W2 to starter relay termi-
nal to which ground wire is connected (third terminal from left) .
Press and release TEST button.
Turn ignition key switch to off position; VTM should display zero.
Turn ignition key switch to on position; VTM should display zero.
Turn ignition key switch to off position.
a. If VTM displays zero, replace starter relay (page 5-26).
b. If VTM displays 24 volts , check for short circuit in wiring con-
nection between ignition key switch connector ST terminal, neu-
t r a l s t a r t s w i t c h , a n d s t a r t e r r e l a y t e r m i n a l . R e p a i r o r r e p l a c e
wiring as necessary (page 5-168 or 5-174).
If wiring is okay, remove right instrument panel (page 5-48) and
replace ignition key switch (page 5-53).
3-273
