TM 5-3805-262-34INSTALLATION (SHEET 1 OF 3)(1)( 2)(3)( 4 )( 5 )Install idler gear shaft (25)in cylinder block.Install thrust washer (24) onidler gear shaft (25).Install idler gear (23), thrustplate (22), and capscrew (21)on idler gear shaft (25).Tighten capscrew to 90 to 96lb-ft.Install camshaft thrust springand thrust plunger.Using a thickness gage,check end clearance of idlergear (23). Measure betweenthrust plate and idler gear.End clearance shall be notmore than 0.010 inch. Re-place thrust plate (22),thrust washer (24), or idlergear (23) in any combinationof parts necessary to obtain0.010 inch or less endclearance.4-71
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business