DISASSEMBLY (SHEET 4 OF 4) - TM-5-3805-262-34

DISASSEMBLY (SHEET 3 OF 4) - TM-5-3805-262-34_1165

DISASSEMBLY (SHEET 4 OF 4) - TM-5-3805-262-34_1167

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1147

TM 5-3805-262-34 4-4. FRONT AND REAR AXLES DIFFERENTIAL ASSEMBLY MAINTENANCE (CONT) a. Differential Carrier (Cont). DISASSEMBLY (SHEET 4 OF 4) NOTE Perform steps (25) through (27) below only if inspection indicates cone and rollers (20) and bearing (22) require replacement. (25) Put pinion (23) in hydraulic press, cone and rollers (20) side up. Put bearing collar on cone and rollers then press pinion (23) shaft from cone and rollers. Discard cone and rollers. NOTE End of pinion (23) shaft is staked against inner race of bearing (22). Be sure to grind end of pinion shaft so that bearing can be removed. (26) Grind end of pinion (23) shaft where it is staked against inner race of bearing (22). (27) Put pinion (23) in hydraulic press, bearing (22) side up, and put collar on bearing. Press pinion shaft from bearing. Discard bearing. (28) If necessary, remove plug (24) from differential carrier (27). (29) If necessary, remove nut (25) and thrust screw (26) from differential carrier (27). 4-222

Privacy Statement
Press Release
Contact