CLEANING - TM-5-3805-262-34

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
287

TM 5-3805-262-34 3-2. FUEL SYSTEM MAINTENANCE (CONT) d. Fuel Injection Pump (Cont ) . CLEANING Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you be- come dizzy while using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water and get medical aid immediately. (1) Scrape gasket material from mating surfaces of timing gear cover, gear cover (8), plates (24 and 61), and housing (68) using putty knife. Remove residue using clean cloth moistened with cleaning solvent P-D-680. Compressed air used for cleaning purposes will not exceed 30 psi. Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure to do so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical attention immediately. (2) (3) (4) (5) Clean housing (68) using clean cloth moistened with cleaning solvent P-D-680. Clear housing (68) bores and dry using compressed air. Clean bearings (on camshaft) and roller tappets by iumersing in cleaning solvent P-D-680 and slowly moving up and down. Dry using compressed air. Direct air stream across bearings and rollers to avoid spinning. Don’t spin bearings or rollers when drying; rotate slowly by hand to facilitate drying. After drying bearings and rollers, lubricate using clean cali- brating fluid. Keep roller tappets and bearing/camshaft assembly in a clean area. Remove protective grease from all new parts using cleaning solvent P-D-680. Dry using compressed air. After drying, lubricate using clean calibrating fluid and keep in a clean area. Clean all other metal parts using cleaning solvent P-D-680. Dry using clean cloths. Lubricate all moving parts using clean calibrating fluid, and keep in a clean area. 3-148

Privacy Statement
Press Release
Contact