TM 5-3805-262-343-5. STARTER REPAIR (CONT)CLEANINGa. Clean armature (27), field coil (37), drive assembly (44), and boot (68) usingclean cloths.Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.Wear protective goggles and gloves and use only in a well ventilatedarea. Avoid contact with skin, eyes and clothes and don’t breathevapors. Do not use near open flame or excessive heat and don’t smokewhen using it. Failure to do so could cause serious injury. If you be-come dizzyattentionwith largewith waterwhile using cleaning solvent, get fresh air and medicalimmediately. If contact with skin or clothes is made, flushamounts of water. If contact with eyes is made, wash eyesand get medical aid immediately.b. Clean all metal parts using cleaning solvent P-D-680. Dry using clean cloths.INSPECTION, TESTING, AND REPAIR (SHEET 1 OF 7)a. Inspect plate and frame assemblies (20 and 21) for cracks, distortion, andthread damage. Replace plate or frame assembly if any of the above conditionsare seen, or if they do not pass the following tests:(1) Hold multimeter red lead on plate assembly (20) terminal stud, black leadon bracket A. Note multimeter indication. Move black lead to bracket Band note multimeter indication. Multimeter should indicate continuity(multimeter pointer should move).(2) Hold multimeter red lead on plate assembly terminal stud, black lead onframe assembly. Multimeter should indicate open circuit (multimeterpointer should not move).3-234
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business