TM 5-3805-262-34
Section VIII. LOADER BUCKET ASSEMBLY MAINTENANCE
This section contains the information you need to maintain
the:
* Bucket
* Loader
It gives
Lift Arms and Pivot Assemblies
Bucket Assembly
you information on how to repair or replace the
components that are within the scope of direct support
maintenance.
Para
Bucket Lift Arms and Pivot Assemblies
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-30
Bucket Lift Arms
. . . . . . . . . . . . . . . . . . . . . . . 3-30a
Tilt Cylinder Assemblies Pivot Shaft . . . . . . . .. 3-30b
Lift Cylinder Assemblies Pivot Shaft
. . . . . . . . . . . 3-30c
Loader Bucket Assembly Maintenance . . . . . . . . . . . . . . . . . . 3-31
NOTE
In following paragraphs, resources required are not listed
unless they apply to the procedure. Personnel required are
listed only if the task requires more than one. If PERSONNEL
REQUIRED is not listed it means one person can do the task.
The normal standard equipment condition to start a
maintenance task is loader bucket lowered to ground, engine
off, loader parked on a level surface, and parking brake
applied. EQUIPMENT CONDITION is not listed unless some other
condition is required besides those indicated above.
3-761
