TM 5-3805-262-34
3-31. LOADER BUCKET ASSEMBLY MAINTENANCE
This task covers disassembly, cleaning, inspection, repair, and reassembly of loader
bucket assembly.
TOOLS: No. 1 Common Organizational
Safety glasses
Combination box and open
Hand hammer, 3 pounds
Scratch wire brush
Lubricating kit
Maintenance Tool Kit
end wrench set
Acetylene torch and tinted goggles
Diagonal cutting pliers
Bore gage
C-clamps, four
Grinder
Chain hoist, 3 ton capacity
Micrometer, zero to 5 inches
Drive pin punch, 1/4 inch point
Drive pin punch, 3/8 inch point
Rod, 1/2 inch diameter by 9 inches long
Rod, 1-3/4 inches diameter by 3 inches long
Rod, 1-3/4 inches diameter by 9 inches long
Rod, 1-3/8 inches diameter by 9 inches long
Wood blocks, 6 by 6 by 12 inches
MATERIALS/PARTS: Clean cloths (Appendix C, item 1)
Cleaning solvent P-D-680 (Appendix C, item 2)
Grease (Appendix C, item 7)
Paint (Appendix C, item 22)
E-7018 welding rods
Cotter pins (FSCM 96906 PN MS24665-353)
REFERENCES: TM 5-3805-262-20
LO 5-3805-262-12
NOTE
PRELIMINARY PROCEDURE: Loader bucket assembly removed (refer to TM
5-3805-262-20).
3-781
