TM 5-3805-262-34
3-30. BUCKET LIFT ARMS AND PIVOT ASSEMBLIES MAINTENANCE (CONT)
c. Lift Cylinder Assemblies Pivot Shaft (Cont).
REMOVAL
(1)
(2)
Using hammer and 2-7/8 inches diameter by 50 inches long
cylinder assemblies pivot shaft from front chassis. Have
port driving end of rod until pivot shaft is driven into
rod, drive lift
assistant sup-
chassis. Then
have assistant move to opposite side to support pivot shaft as it is
driven out.
If necessary to replace bushings, use hammer and cold chisel to split
bushings from front to back. Then use slip joint pliers to remove bush-
ings from bores.
3-778
