TM 5-3805-262-34
INSTALLATION OF WEAR SLEEVE AND OVERSIZED
(b) Install wear sleeve with cham-
fer on inside diameter end
first on crankshaft flange.
(c) Using seal and sleeve posi-
tioning tool and a hammer,
press and position wear
sleeve.
(d) Lubricate new rear oversized
oil seal lip using grease.
Then, after wear sleeve has
cooled to room temperature,
install new rear oil seal
using hammer and seal and
sleeve positioning tool.
(e) Install flywheel (page 3-59) .
(f) Install flywheel housing (page
REAR OIL SEAL (SHEET 2 OF 2)
3-56) .
---
4-41
