TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
2. Check harness.
1. If each resistance measurement is
0367 04 -
(a) Turn battery disconnect switch and
greater than 5,000 Ohms, replace
Cont.
engine start switch to OFF position
machine ECM (WP 0052 00).
2. If one or more resistance
(b) Wiring harness remains disconnected
measurements is less than 5.0 Ohms,
from ride control switch.
short is between J2-45 (wire E701 PK)
(c) Disconnect wiring harness
and circuit with lowest resistance, or
connector(s) from machine ECM (WP
short is between J2-46 (wire F748 WH)
0052 00).
and circuit with lowest resistance.
(d) Measure resistance between contacts
Replace wiring harness in question
J2-45 (wire E701 PK) and J2-46 (wire
(WP 0169 00 thru WP 0175 00).
F748 WH) of wiring harness to all
contacts used in ECM wiring harness
connectors.
3. Check ride control switch operation.
1. If resistance measurements are greater
(a) Wiring harness remains disconnected
than 5,000 Ohms, go to Test 4.
from ride control switch. Place switch 2. If one resistance measurement is less
in OFF position.
than 5.0 Ohms, replace ride control
(b) Connect one lead from multimeter to
switch (WP 0049 00).
contact 2 (wire 202 BK) of switch
harness connector.
(c) Connect other lead from multimeter to
contact 1 (wire E701 PK) of switch
harness connector.
(d) Measure resistance between contact 2
(wire 202 BK) and contact 1 (wire
E701 PK).
(e) Disconnect lead from contact 1 (wire
E701 PK) and connect lead to contact
3 (wire F748 WH).
(f) Measure resistance between contact 2
(wire 202 BK) and contact 3 (wire F748
WH).
0009 00-39