TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0629 04
427-B1868
N OT E
This test procedure may create other diagnostic codes. Ignore these diagnostic
codes and clear diagnostic codes when original diagnostic code has been cor-
rected. Ensure diagnostic code CID 0629 FMI 04 is active before performing this
procedure.
1. If resistance is greater than 5,000
1. Check transmission neutralizer override
Ohms, go to Test 2.
switch.
2. If resistance is less than 5.0 Ohms,
(a) Turn engine start switch and battery
switch has failed. Replace transmission
disconnect switch to OFF position (TM
neutralizer override switch (WP 0049
00).
(b) Disconnect transmission neutralizer
override switch (WP 0049 00).
(c) At switch, measure resistance from
contact connected to wire 702 OR to
contact connected to wire 202 BK.
1. If resistance is greater than 5,000
2. Check wiring harness.
Ohms, go to Test 3.
(a) Disconnect wire 702 OR from switch.
2. If resistance is less than 5.0 Ohms, wire
Remove wire 702 OR from J2 harness
is shorted to ground. Replace wiring
connector.
harness in question (WP 0169 00 thru
(b) Measure resistance from 702 OR to
WP 0175 00).
frame ground.