TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0600 04
427-B1867
1. Check hydraulic oil temperature sensor.
1. If diagnostic code changed from CID
(a) Connect MSD (WP 0006 00).
0600 FMI 04 to CID 0600 FMI 03,
replace hydraulic temperature sensor
(b) Disconnect wiring harness from
(WP 0070 00).
hydraulic temperature sensor (WP
2. If diagnostic code remains, go to Test 2.
0070 00).
1. If resistance is greater than 5,000
2. Check harness.
Ohms, replace machine ECM (WP
(a) Hydraulic oil temperature sensor
0052 00).
remains disconnected from wiring
2. If resistance is less than 5,000 Ohms,
harness.
there is a short between frame ground
(b) Turn battery disconnect switch and
and signal circuit in wiring harness.
engine start switch to OFF position
Replace wiring harness in question
(WP 0169 00 thru WP 0175 00).
(c) Disconnect J1 and J2 wiring harness
connectors from machine ECM (WP
0052 00).
(d) At hydraulic oil temperature sensor
wiring harness connector, measure
resistance between signal contact 1
(wire 442 GY) and frame ground.