TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1. Check shift lever signal on ET status screen. 1. If shift lever position status changes
0668 02 -
properly, go to Test 6.
(a) Disconnect F/N/R switch harness 4-pin
Cont.
2. If status on ET screen is "DATA
connector CN-C50 from shift lever.
FAULT" in all shifter positions, go to
Connect a jumper wire from pin 3 to pin
Test 2.
4 on shifter 4-pin connector (WP 0081
3. If status on ET screen is "DATA
00).
FAULT" in a particular position, go to
(b) Connect MSD (WP 0006 00).
Test 3.
(c) Turn battery disconnect switch and
engine start switch to ON position (TM
(d) Select powertrain ECM and go to status
screen 4.
(e) Move shift lever through all possible
positions. Observe status of "Shift
Lever Position" on ET screen (TM 5-
3805-290-10).
2. Check for power and ground at shifter.
1. If voltage is system voltage, go to Test
(a) At shifter, connect positive (red)
4.
multimeter lead to wire 110 GN.
2. If voltage is not system voltage, go to
Connect negative (black) multimeter
Test 3.
lead to wire 200 BK.
(b) Measure voltage between two wires.
3. Check fuse for wire 110 GN (WP 0210 00).
1. If fuse is bad, replace fuse (WP 0054
00).
2. If fuse is good, wiring harness may
have failed. Replace wiring harness
between fuse and shifter or between
shifter and ground (WP 0169 00 thru
WP 0175 00).
0009 00-80