TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1. If shift lever position status changes
6. Verify shift lever remote F/N/R switch
0668 02 -
properly, monitor machine to see if
functionality.
Cont.
problem occurs. If problem occurs,
(a) Place shift lever on steering column in
repeat entire test procedure again.
NEUTRAL and FIRST GEAR (TM 5-
2. If status on ET screen is "DATA
3805-290-10).
FAULT" in either a particular position
(b) At shifter 4-pin connector, remove
or all positions, go to Test 7.
jumper wire between pin 3 and pin 4.
(c) Connect 4-pin receptacle connector
CN-C50 from cab harness to shifter 4-
pin plug. This will enable remote F/N/
R switch circuit for shift lever.
(d) Ensure pins and sockets are seated
properly, and that connector mates
correctly.
(e) Place remote F/N/R switch in
FORWARD position (TM 5-3805-
290-10).
(f) Verify ET shows "F1" as desired gear.
(g) Place remote F/N/R switch in
REVERSE position.
(h) Verify ET shows "R1" as desired gear.
7. Verify shift lever remote F/N/R harness.
1. If shift lever position status changes
(a) Ensure shift lever on steering column
properly, replace remote F/N/R switch
is in NEUTRAL and FIRST GEAR
assembly (WP 0188 00).
2. If status on ET screen is "DATA
(b) Ensure cab harness 4-pin receptacle
FAULT" no matter which wire is
connector CN-C50 is connected to
jumpered to pin 1, common signal pin
shifter 4-pin plug.
1 202 BK may have lost connection to
(c) Disconnect 6-pin connector from
machine ground. Repair wiring harness
remote F/N/R switch assembly (WP
in question (WP 0169 00 thru WP 0175
0176 00).
00).
(d) On cab harness connector CN-C23,
3. If status on ET screen is "DATA
place a jumper wire from pin 1 202 BK
FAULT" when a particular wire is
to pin 4 G787 GN.
jumpered to pin 1, replace wiring
(e) Verify ET shows "F1" as desired gear.
harness in question (WP 0169 00 thru
(f) Move jumper wire connection to pin 1
WP 0175 00).
202 BK and pin 6 G788 YL.
(g) Verify ET shows "R1" as desired gear.
(h) Move jumper wire connection to pin 1
202 BK and pin 5 P916 OR.
(i) Verify ET shows "N1" as desired gear.
0009 00-82
