TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1406 03
427-B1885
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1406 FMI 03 is active before per-
forming this procedure.
1. Check clutch 6 (first speed) solenoid
1. If each resistance measurement is
energize circuit for a short to +battery circuit.
greater than 5,000 Ohms, go to Test 2.
(a) Turn engine start switch and battery
2. If each resistance measurement is not
disconnect switch to OFF position (TM
greater than 5,000 Ohms, there is a
short between J1-48 (755 OR) and
(b) Disconnect wiring harness connectors
circuit resistance measurement.
from clutch 6 (first speed) solenoid
Replace wiring harness in question
(WP 0177 00) and machine ECM (WP
(WP 0169 00 thru WP 0175 00).
0052 00).
(c) At ECM wiring harness connector,
measure resistance from contact J1-48
(wire 755 OR) to all contacts used in
ECM wiring harness connectors.