TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1406 05
427-B1885
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1406 FMI 05 is active before per-
forming this procedure.
1. If diagnostic code remains active, go to
1. Check clutch 6 (first speed) solenoid.
(a) Turn battery disconnect switch and
Test 2.
engine start switch to ON position (TM 2. If diagnostic code is no longer active,
5-3805-290-10). Do not start engine.
clutch 6 (first speed) solenoid has
(b) Disconnect clutch 6 (first speed)
failed. Repeat this test to verify clutch
solenoid (WP 0177 00) from wiring
6 (first speed) solenoid failure. Replace
harness.
modulating valve (WP 0177 00).
(c) At clutch 6 (first speed) solenoid wiring
Verify new modulating valve corrects
harness connector, place a jumper wire
problem.
from contact 1 (wire 755 OR) to contact
2 (wire 975 WH).
(d) Connect MSD (WP 0006 00) and
observe status of CID 1406 FMI 05.
