TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(c) At wiring harness connector for ECM,
1. If each resistance measurement is
1405 03 - Continued.
measure resistance from contact J1-51
greater than 5,000 Ohms, go to Test 2.
(900-PU) to all contacts used in wiring
2. If each resistance measurement is not
harness connectors for ECM.
greater than 5,000 Ohms, short is
between J1-51 (900-PU) and circuit
with low resistance measurement.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
2. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to determine if CID
1. If CID 1405 FMI 03 is active, exit this
1405 FMI 03 is active (TM 5-3805-
procedure and repeat this procedure. If
291-10).
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 1405 FMI 03 is not active,
problem does not exist at this time.
Resume normal machine operation.
1405 05
427-C1638
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when
original diagnostic code is corrected. Ensure diagnostic code CID 1405
FMI 05 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).