TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1. If CID 1405 FMI 05 is active, exit this
(e) Use messenger to check status of CID
1405 05 - Continued.
1405 FMI 05 (TM 5-3805-291-10).
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 1405 FMI 05 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
1405 06
427-C1638
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when
original diagnostic code is corrected. Ensure diagnostic code CID 1405
FMI 06 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).
(b) Connect MSD (WP 0005 00) and
observe status of diagnostic code.
1. If CID 1405 FMI 06 changes to CID
(c) Disconnect solenoid with active
1405 FMI 05 when solenoid is
diagnostic code from wiring harness
disconnected, repeat this test to verify
(WP 0203 00).
solenoid failure. Replace modulating
value with active code (WP 0203 00).
Verify new solenoid corrects problem.
2. If CID 1405 FMI 06 remains active, go
to Test 2.
2. Check solenoid energizer circuit for a short
to ground.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
