TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Check for short to +battery circuit.
0296 02 - Continued.
(a) Battery disconnect switch remains
in OFF position (TM 5-3805-291-
10).
(b) All related ECMs remain
disconnected from wiring harness.
(c) At wiring harness connector for
implement ECM, perform these
checks:
(1) Measure resistance between con-
nector contact J1-31 (wire 197-
RD) and connector contact J1-10
(wire 944-OR).
(2) Measure resistance between con- 1. If wiring harness circuit resistance is
correct, go to Test 5.
nector contact J1-31 (wire 197-
RD) and connector contact J1-20 2. If resistance is less than 5,000 Ohms,
(wire 945-BR).
wiring harness has failed. Replace wiring
harness in question (WP 0195 00 thru
WP 0201 00).
5. Check for open circuit in wiring harness.
(a) Battery disconnect switch remains
in OFF position (TM 5-3805-291-
10).
(b) All related implement ECMs
remain disconnected from wiring
harness.
(c) Check continuity of CAT Data
Link circuit in wiring harness:
(1) Measure resistance between con-
nector contact J1-10 (wire 944-
OR) and connector contact J1-10
(wire 944-OR) of powertrain
ECM.
(2) Measure resistance between con- 1. If resistance is less than 5 Ohms, go to
nector contact J1-20 (wire 945-
Test 6.
BR) of implement ECM and
2. If resistance is greater than 5 Ohms,
connector contact J1-20 (wire
replace wiring harness in question (WP
945-BR).
0195 00 thru WP 0201 00).
0009 00-168