TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Observe ON/OFF status of
1. If diagnostic code indicator is inactive,
0492 13 - Continued
diagnostic code indicator as
calibration corrected diagnostic code.
auxiliary function is fully actuated.
Clear diagnostic code.
2. If diagnostic code indicator is active,
perform calibration for main control
valve again. Also, ensure diagnostic code
indicator is active for this diagnostic
code. If cause is not found, replace
solenoid (WP 0218 00) and perform
calibration again. If this does not
eliminate diagnostic code, replace
implement ECM (WP 0060 00).
427-C1668
1. Connect MSD (WP 0005 00) and verify
0590 02
hardware and software part numbers.
Verify the following information is correct:
(a) Part number for configuration
software of implement ECM.
(b) Part number of engine ECM flash
software.
(c) Part number of implement ECM.
(d) Part number of engine ECM.
1. If all part numbers are correct, go to Test
2.
2. If all part numbers are not correct, part
numbers of implement ECM or engine
ECM may be incorrect. Incorrect
configuration software may also be
installed. Replace incorrect implement
ECM with an implement ECM that has
correct part number (WP 0060 00).