TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1667
N OT E
0492 03
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear these diagnostic codes when original diagnos-
tic code has been corrected.
Return lines for solenoids are joined and return lines connect to contact J1-60
(wire J813-BK) of implement ECM.
Ensure diagnostic code indicator is active and diagnostic code is active.
This test causes implement ECM to logan open circuit diagnostic code for this
solenoid. Clear this code from implement ECM after troubleshooting.
1. Check solenoid.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect auxiliary forward
proportioning solenoid from wiring
harness (WP 0218 00).
(c) Turn engine start switch to ON
position (TM 5-3805-291-10).
(d) Place direction lever in NEUTRAL
position.
(e) At wiring harness connector for
1. If voltage is approximately 5 DCV,
solenoid, measure voltage from
solenoid has failed. Replace solenoid
implement ECM between contact 1
(WP 0218 00).
(wire E919-YL) to contact 2 (wire 2. If voltage is approximately battery
J813-BK).
voltage, go to Test 2.
2. Check wiring harness.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect wiring harness from
implement ECM (WP 0060 00).