TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1667
N OT E
0492 05
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected
Return lines for solenoids are joined and return lines connect to contact J1-60
(wire J813-BK) of implement ECM.
Ensure diagnostic code indicator is active and diagnostic code is active.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Disconnect auxiliary forward
proportioning solenoid from wiring
harness (WP 0218 00).
(c) Observe ON/OFF status of
diagnostic code indicator.
(d) At wiring harness connector for
1. If diagnostic code indicator remains
solenoid, place a jumper wire
active, go to Test 2.
between contact 1 (wire E919-YL)
2. If diagnostic code indicator is inactive,
and contact 2 (wire J813-BK).
solenoid or connecting harness has
failed. Repeat this test to verify failure.
Replace solenoid (WP 0218 00). Replace
wiring harness in question (WP 0195 00
thru WP 0201 00). Approximate
resistance of proportional solenoid valve
is from 6 to 12 Ohms.
2. Check wiring harness.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).