TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Check solenoid.
0492 06 - Continued,
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Observe ON/OFF status of
diagnostic code indicator.
(c) Disconnect auxiliary forward
1. If diagnostic code indicator remains
proportioning solenoid from wiring
active, harness or implement ECM has
harness (WP 0218 00).
failed. Go to Test 2.
2. If diagnostic code indicator is inactive,
solenoid or connecting harness has
failed. Repeat this test to verify failure.
Replace solenoid (WP 0218 00). Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
2. Check for shorted wiring harness.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(b) Solenoid valve remains
disconnected.
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is less than 5,000 Ohms,
implement ECM, measure
wiring harness has failed. Replace wiring
resistance between contact for
harness in question (WP 0195 00 thru
failed solenoid circuit J1-58 (wire
WP 0201 00).
E919-YL) and contact J1-60
2. If resistance is greater than 5,000 Ohms
(ground wire J813-BK).
(no continuity), harness circuit resistance
is correct. Exit this procedure and repeat
this troubleshooting procedure. Also,
recheck if diagnostic code indicator is
active for this diagnostic code. If cause is
not found, replace implement ECM (WP
0060 00).
N OT E
0492 13
Ensure diagnostic code is active.
Check calibration of main control valve.
(a) Calibrate main control valve (WP
(b) Recheck diagnostic code.
(c) Ensure diagnostic code is active.