TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
1187 03
Switch Continuity, Table 6 contains wire numbers and connector con-
tacts. Use this information to troubleshoot the failed circuit.
1. Check for open circuit.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(c) Verify that implement lockout
switch is connected.
(d) Disconnect harness from ECM
(WP 0060 00).
(e) Activate switch. At harness
1. If continuity check does not agree with
Switch Continuity, Table 6 at end of this
connector for ECM, check
continuity to ground of normally
work package, proceed to Test 2.
closed contact and the normally
2. If continuity agrees with the values in
open contact.
Switch Continuity, Table 6 at the end of
this work package, proceed to Test 3.
2. Check switch.
(a) Disconnect harness from switch
(WP 0055 00).
(b) At harness connector for ECM,
1. If continuity check does not agree with
Switch Continuity, Table 6 at the end of
check continuity to ground of
normally closed contact and
this work package, switch has failed.
normally open contact. Activate
Replace the switch.
switch when this check is being
2. If continuity check agrees with Switch
performed.
Continuity, Table 6 at the end of this
work package, harness has failed. Repair
harness (WP 0022 00).
