TM 5-3805-292-23
0087
REMOVAL
00087
C AU T I O N
Cap all hydraulic hose and line ends along with component connections during removal to
protect against contamination. Failure to follow this caution may result in damage to
equipment.
N OT E
Tag all hoses and lines to aid in installation.
1. Disconnect two hydraulic hose fittings (Figure 1, Item 5) and remove hydraulic hoses (Figure 1, Item 1) and
two O-rings (Figure 1, Item 2) from tilt cylinder (Figure 1, Item 9). Discard O-rings from lower fitting.
2. Remove elbow (Figure 1, Item 3) and nut (Figure 1, Item 4) from tilt cylinder (Figure 1, Item 9).
3. Remove nut (Figure 1, Item 10), washer (Figure 1, Item 11), bolt (Figure 1, Item 13), washer (Figure 1, Item
14), spacer (Figure 1, Item 12), pin (Figure 1, Item 15), and spacers (Figure 1, Item 16) from machine.
N OT E
If only seal kit replacement is required, proceed toDisassembly in this work package.
Tilt cylinder weighs 45 lb.
4. Remove nut (Figure 1, Item 6), bolt (Figure 1, Item 7), pin (Figure 1, Item 8), and tilt cylinder (Figure 1, Item 9)
from machine.
Figure 1. Tilt Cylinder.
0087
END OF TASK
