8
TM 5-2420-231-23-3
FIELD MAINTENANCE
-
RIDE CONTROL ACCUMULATOR ASSEMBLY REPLACEMENT
0267
Removal, Cleaning and Inspection, Installation, Checking Nitrogen Charge, Charging Accumulator
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
Tool Kit, General Mechanic's
Tag, Marker (WP 0375, Item 33)
0
0
(WP 0376, Item 117)
Lockwasher (4)
0
Charging and Testing Unit, Nitrogen
O-ring (3)
0
0
(WP 0376, Item 12)
References
Gloves, Rubber (WP 0376, Item 32)
0
Headgear, 170S (WP 0376, Item 37)
0
0
WP 0374 (Group Number 0718 and 0734)
Pan, Drain, 5 gal. Capacity (WP 0376, Item 54)
0
0
Visor, Clear 915-60 (WP 0376, Item 124)
Equipment Conditions
0
Machine parked (TM 5-2420-231-10)
Materials/Parts
0
Cap Set, Protective, Dust and Moisture
Estimated Time to Complete
0
(WP 0375, Item 4)
2.0 hr
0
Nitrogen, Technical, Dry Cylinder
0
(WP 0375, Item 21)
Rag, Wiping (WP 0375, Item 25)
0
WARNING
Allow hydraulic system to cool before performing procedure. Hot metal parts can cause
severe burns. Wear eye, hand, and skin protection when working with heated parts.
Hydraulic oil is very slippery. Immediately wipe up any spills.
Hydraulic oil pressure can remain in the hydraulic system after the engine has been
stopped. Serious injury can be caused if this pressure is not released before any service is
done on the hydraulic system.
Failure to follow these warnings may result in injury or death to personnel.
CAUTION
Plug and cap all hoses and fittings to prevent contamination. Failure to follow this caution
may result in damage to the machine.
NOTE
Tag and mark lines to aid in installation.
0267-1