TM 5-2420-231-23-3
0278
REMOVAL CONTINUED
NOTE
Note adjustment of cable to aid in assembly.
38. Loosen jamnut (Figure 16, Item 6) and remove clevis (Figure 16, Item 7) from cable (Figure 16, Item 5).
39. Remove cotter pin (Figure 16, Item 3) and pin (Figure 16, Item 2) from clevis (Figure 16, Item 4). Discard cotter
pin.
40. Disconnect cable (Figure 16, Item 5) from cam (Figure 16, Item 1).
Figure 16. Cam and Cable.
0278
END OF TASK
CLEANING AND INSPECTION
0278
1. Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0369).
2. Clean and inspect all parts IAW Electrical General Maintenance Instructions (WP 0370).
END OF TASK
INSTALLATION
0278
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may result in injury or death to personnel.
1. Connect cable (Figure 16, Item 5) to cam (Figure 16, Item 1).
2. Install pin (Figure 16, Item 2) and new cotter pin (Figure 16, Item 3) on clevis (Figure 16, Item 4).
NOTE
Adjust cable as noted during removal.
3. Install clevis (Figure 16, Item 7) on cable (Figure 16, Item 5), and tighten jamnut (Figure 16, Item 6).
