TM 5-3805-255-14
0080
CLEANING AND INSPECTION
00080
1. Clean and inspect all parts IAW General Maintenance Instructions (WP 0019).
2. Carefully inspect all components for signs of excessive wear, cracks, or damage. Replace if necessary.
3. Inspect control lever and bellcrank bushings for wear or damage. Replace if necessary.
END OF TASK
ASSEMBLY
00080
CAUTION
Do not install grease fittings. Pressure lubrication may cause serious damage to bushings.
1. Install seven bushings (Figure 5, Items 7, 8, 11, and 15) in two control levers (Figure 5, Items 3 and 5). Hand
pack bushings with grease.
2. In cab, install control lever pin (Figure 5, Item 2), and two control levers (Figure 5, Items 3 and 5) on mounting
brackets.
3. Install six spacer washers (Figure 5, Item 6), flat washer (Figure 5, Item 9), and nut (Figure 5, Item 10) on
control lever pin (Figure 5, Item 2).
4. Install two bolts (Figure 5, Item 1), new lockwashers (Figure 5, Item 17), and nuts (Figure 5, Item 16) on each
end of control lever pin (Figure 5, Item 2).
5. Install two cable ends (Figure 5, Item 13) on control levers (Figure 5, Items 3 and 5). Install two clevis pins
(Figure 5, Item 12) on cable ends (Figure 5, Item 13). Install two new cotter pins (Figure 5, Item 14) on clevis
pins.
0080-6