TM 5-3805-262-20
INSTALLATION (SHEET 4 OF 4)
NOTE
B e c a r e f u l w h e n p e r f o r m i n g f o l l o w i n g s t e p n o t t o d a m a g e s e a l ( 1 8 )
located on block assembly (17).
(15)
Beneath cab deck, install block assembly (17) on control shaft (23) by
carefully inserting shaft through seal (18) and moving block up onto
shaft and into position on welded bracket. Be careful not to damage seal
(18) when performing this procedure.
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
(24)
Secure block assembly (17) using lock washer (16) and capscrew (15).
I n s t a l l l u b r i c a t i o n f i t t i n g ( 1 4 ) i n s i d e o f b l o c k a s s e m b l y ( 1 7 ).
Install washer (13), spring (12), washer (11), and clamp assembly (10) on
control shaft (23) then install lever (9) on clamp assembly; support
clamp assembly and lever.
Install two lock washers (8) and nuts (7). Compress spring (12) to length
of 1.4 to 1.6 inches. Tighten nuts (7) evenly.
Install nut (5), if removed, on cable assembly (4). Thread completely
onto cable shaft.
If removed, i n s t a l l b a l l j o i n t ( 3 ) o n c a b l e ( 4 ).
Position ball joint (3) in cable lever (9); secure with lock washer (2)
a n d n u t ( l ).
L u b r i c a t e l u b r i c a t i o n f i t t i n g ( 1 4 ) ( r e f e r t o c u r r e n t l u b r i c a t i o n o r d e r ) .
Adjust control valve linkage (page 6-18).
6-17
