TM 5-3805-262-344-4. FRONT AND REAR AXLES DIFFERENTIAL ASSEMBLY MAlNTENANCE (CONT)b. DifferentialCaseandGearAssembly(Cont).CLEANINGDry cleaning solvent P-D-680 used to clean parts is toxic and flammable.Wear protective goggles and gloves and use only in a well ventilatedarea. Avoid contact with skin, eyes and clothes and don’t breathevapors. Do not use near open flame or excessive heat and don’t smokewhen using it. Failure to do so could cause serious injury. If you be-come dizzy while using cleaning solvent, get fresh air and medicalattention immediately.If contact with skin or clothes is made, flushwith large amounts of water. If contact with eyes is made, wash eyeswith water and get medical aid immediately.Compressed air used for cleaning purposes will not exceed 30 psi. Useonly with effective chip guarding and personal protective equipment(goggles/shield, gloves, etc). Failure to do so could cause seriousinjury to eyes and possible blindness.If you hurt your eyes or if aforeign object is blown into your eyes, seek medical attentionimmediately.(1) Clean cone and rollers (10) by immersing in cleaning solvent P-D-680 andslowly moving up and down. Remove cone and rollers from cleaning solventand strike larger side of cone against a block of wood to dislodge solid-ified particles of lubricant. Immerse again in cleaning solvent andrepeat above until cone and rollers are clean. Dry using compressed air.Direct air stream across cone and rollers to avoid spinning. Don’t spincone and rollers when drying; rotate slowly by hand to facilitate drying.After drying, lubricate using clean hypoid gear oil. Keep in a cleanarea.(2)Clean remaining parts using cleaning solvent P-D-680. Dry using com-pressed air or clean cloths.4-236
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
