TM 5-3805-262-34
3-2. FUEL SYSTEM MAINTENANCE (CONT)
d. Fuel Injection Pump (Cont).
REASSEMBLY (SHEET 3 OF 12)
LEGEND
49. Screws (3)
50. clamps (3)
51. clamps (3)
52. Delivery valve holders (6)
53. Pistons (6)
54. O-rings (6)
55. Springs (6)
56. Gaskets (6)
57. Delivery valves (6)
58. Barrels (6)
NOTE
In following steps , install plunger, valve, and roller tappet parts in
original housing bores as tagged. Keep mating parts together. Dip all
moveable parts in clean calibrating fluid.
(8)
Install six valve assemblies and pressure test housing:
(a) Lower barrel (58) into housing top bore
, with guide groove in barrel
alined with locking pin in housing.
(b) Install delivery valve (57) .
(c) Install gasket (56) and spring (55) .
(d) Install piston (53) and new O-ring (54).
3-154
