TM 5-3805-262-343-2. FUEL SYSTEM MAINTENANCE (CONT)d. Fuel Injection Pump (Cont).REASSEMBLY (SHEET 7 OF 12)(14) Install roller tappet assemblies:(a)(b)(c)(d)(e)(f)Grasp roller tappet using tappet tongs and insert through housing bore.Reach through housing bottom bore using second tappet tongs, grasp roll-er tappet, and aline tappet pin so it will easily go into guide groovein housing bore.Push roller tappet against spring usingtappet tongs until tappet holder can beinserted between tappet capscrew andnut. As you push roller tappet againstspring, use an awl to ensure thatplunger foot lines up with slot in con-trol sleeve.Install tappet holder with nose of bot-tom pawl between tappet capscrew andnut.Press lever while guiding top pawl intohousing recess, then remove tappettongs.Repeat steps (a) through (e) above toinstall remaining roller tappets andtappet holders in firing order sequence1-5-3-6-2-4.3-158
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business