TM 5-3805-262-34INSTALLATION (SHEET 2 OF 2)(6)(7)(8)(9)(10)(11)(12)(13)LEGENDInstall new O-ring (6), two shims (5) and thrust washer (4) on pin (7)inside cab just below instrument panel.Put new retaining ring (3) in vise. Using a prybar, open retaining ringand install 7/8 inch wood block between ends of retaining ring as shown.Install retaining ring (3) onpin (7).Install two lubricationfittings (2 and 1).Repeat steps (4) through (9)above to secure other side ofbucket lift arm to front chas-sis.Install loader bucket assemblyand associated lines and fit-tings (refer to TM 5-3805-262-20).Install lift and tilt cylinder assemblies (refer to TM 5-3805-262-20).Lubricate lubrication fittings on bucket lift arm (refer to LO 5-3805-262-12).1. Lubrication fittings (2)2. Lubrication fittings (2)3. Retaining rings (2)4. Thrust washers (2)5. Shims (4)6. O-rings (2)7. Pins (2)8. Thrust washers (2)3-773
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
