TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0291 03
427-B1856
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 0291 FMI 03 is active before per-
forming this procedure.
1. Check solenoid energize circuit for a short to 1. If each resistance measurement is
+battery circuit.
greater than 5,000 Ohms, go to Test 2.
(a) Turn engine start switch and battery
2. If each resistance measurement is not
disconnect switch to OFF position (TM
greater than 5,000 Ohms, there is a
short in wiring harness between J1-67
(b) Disconnect wiring harness connectors
(E998 YL) and circuit that has a low
from solenoid (WP 0187 00) and
resistance measurement. Replace
machine ECM (WP 0052 00).
wiring harness in question (WP 0169
(c) At ECM wiring harness connector,
00 thru WP 0175 00).
measure resistance from contact J1-67
(wire E998 YL) to all contacts used in
ECM wiring harness connector.