TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(d) At wiring harness connector for
1. If each resistance measurement is greater
0351 03 - Continued.
implement ECM, measure
than 5,000 Ohms, go to Test 5.
resistance from signal contact J2-
2. If one or more resistance measurements
33 (wire H718-GY) of wiring
is not correct, short is between signal
harness to all possible sources of
contact J2-33 (wire H718-GY) and
+battery circuit. Measure
circuit with low resistance measurement.
resistance to all contacts used in J2
Replace wiring harness in question (WP
and J1 wiring harness connectors.
0195 00 thru WP 0201 00).
5. Check sensor output.
(a) Reconnect wiring harness
connectors to implement ECM.
Reconnect wiring harness
connector to sensor.
(b) At wiring harness connector for
sensor, connect positive lead from
multimeter to contact C.
(c) At wiring harness connector for
sensor, connect negative lead from
multimeter to contact B.
(d) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(e) Set multimeter to setting for
1. If PWM signal from sensor is 500 Hz
frequency (Hz). Measure output of
signal between 5% and 95%, go to Test 6.
sensor.
2. If PWM signal from sensor is not 500 Hz
signal or signal is not between 5% and
95%, replace sensor (WP 0089 00).
6. Connect MSD (WP 0005 00) and Check
if diagnostic code remains active.
(a) Disconnect, inspect, and clean
wiring harness connector contacts.
Refer to Electrical Connectors
Inspection (WP 0022 00) as
necessary.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
0009 00-184