TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Observe ON/OFF status of
1. If diagnostic code indicator is inactive,
0351 13 - Continued.
diagnostic code indicator as bucket
clear diagnostic code.
is tilted back and dumped fully.
2. If diagnostic code indicator is active,
perform calibration for tilt linkage
position sensor again. Also, ensure
diagnostic code is active. If cause is not
found, replace sensor (WP 0089 00) and
perform calibration again. If this does not
eliminate diagnostic code, replace
implement ECM (WP 0060 00).
427-C1654
N OT E
0352 00
0352 01
The following procedure may create other diagnostic codes. Ignore these created
diagnostic codes and clear diagnostic codes when original diagnostic code is cor-
rected.
Ensure diagnostic code is active before performing procedure.
Recalibrate lever position sensor (WP
1. If calibration causes diagnostic code to
become inactive, resume normal
machine operation.
2. If calibration has not caused diagnostic
code to become inactive, replace joystick
(WP 0219 00).
