TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. If diagnostic code indicator is active,
0357 13 - Continued
repeat calibration for main control valve.
Also, ensure diagnostic code is active. If
cause is not found, replace solenoid (WP
0218 00) and perform calibration again.
If this does not eliminate diagnostic code,
replace implement ECM (WP 0060 00).
427-C1660
N OT E
0358 03
Solenoid return lines connect to contact J2-4 (wire K927-BU) of implement
ECM.
The following procedure may create other diagnostic codes. Ignore these created
diagnostic codes and clear diagnostic codes when original diagnostic code is cor-
rected.
Ensure diagnostic code is active and diagnostic code indicator is active.
This test causes implement ECM to logan open circuit diagnostic code for this
solenoid. Clear this code from implement ECM after troubleshooting.
1. Check solenoid.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect pilot solenoid from
wiring harness (WP 0218 00).
(c) Turn engine start switch to ON
position (TM 5-3805-291-10).