TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. If diagnostic code indicator is inactive,
0491 05 - Continued.
repeat this test to verify failure. Replace
solenoid (WP 0218 00). Replace
connecting wiring harness in question
(WP 0195 00 thru WP 0201 00).
Approximate resistance of a proportional
solenoid valve is from 6 to 12 Ohms.
N OT E
Approximate resistance of proportional solenoid valve is from 6 to 12
Ohms.
2. Check wiring harness.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(b) Remove jumper wire from contact
1 to 2.
(c) Reconnect solenoid valve to
harness.
(d) Disconnect wiring harness from
implement ECM (WP 0060 00).
(e) At wiring harness connector for
1. If resistance is greater than 5,000 Ohms
implement ECM, measure
(no continuity), harness has failed.
resistance between contacts J1-60
Replace wiring harness in question (WP
(wire J813-BK) and contact J1-59
0195 00 thru WP 0201 00).
(wire E920-BR).
2. If resistance is from 6 to 12 Ohms, exit
this procedure and perform this
troubleshooting procedure again. Also,
recheck if diagnostic code indicator is
active for this diagnostic code. If cause is
not found, replace implement ECM (WP
0060 00).
0009 00-246