TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Disconnect and inspect wiring
1326 02 - Continued.
harness connections that are related
to location codes (WP 0237 00).
Make sure that connectors are clean
and tight. Refer to Electrical
Connectors Inspection (WP 0022
00) as necessary.
(c) Check for proper mating of
connector.
(d) Check all wires at connector.
(e) Check each wire for nicks. Check
each wire for signs of abrasion in
insulation.
(f) Check all wires at connector.
(g) Check each wire for nicks. Check
each wire for signs of abrasion in
insulation.
(h) Check for moisture at connector.
(i) Check for dirty contacts or
corroded contacts.
(j) Check each pin and check each
socket.
(k) Reconnect all connectors.
1. If wiring harness connectors are tight and
free from corrosion, go to Test 4.
2. If one or more wiring harness connectors
are in need of repair, replace wiring
harness in question (WP 0195 00 thru
WP 0201 00).
4. Check for shorts to ground.
(a) Battery disconnect and engine start
switches remain in OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness from
implement ECM (WP 0060 00).
(c) At wiring harness for implement
1. If resistance measured is greater than 5
ECM, measure resistance between
Ohms at contacts J1-28 and J1-27 and
frame ground and location code
resistance measures less than 5 Ohms at
pins.
contact J1-26 and J1-32, go to Test 5.
2. If one or more resistance measurements
is not correct, replace wiring harness in
question (WP 0195 00 thru WP 0201 00).
0009 00-271
