TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5. Check for shorts to +battery circuit.
1326 02 - Continued.
(a) Battery disconnect switch remains
OFF (TM 5-3805-291-10).
(b) Implement ECM remains
disconnected from wiring harness
connector.
(c) At wiring harness connector for
1. If resistance is greater than 5 Ohms, go
implement ECM measure
to Test 6.
resistance between J1-26 and J1-32 2. If resistance is less than 5,000 Ohms,
to all possible sources of +battery
replace wiring harness in question (WP
circuit.
0195 00 thru WP 0201 00).
6. Check for an open circuit in wiring
harness.
(a) Battery disconnect switch remains
in OFF position (TM 5-3805-291-
10).
(b) Implement ECM remains
disconnected from wiring harness.
1. If resistance is less than 5 Ohms,
(c) At wiring harness for implement
implement ECM has failed. Exit this
ECM, measure resistance between
procedure and perform this diagnostic
frame ground and contacts J1-28
code procedure again. If cause of
and J1-32.
diagnostic code is not found, replace
implement ECM (WP 0060 00).
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
0009 00-272
