TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1672
2326 03
N OT E
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected.
Ensure diagnostic code indicator is active and that diagnostic code is active.
This test causes implement ECM to logan open circuit diagnostic code for this
solenoid. Clear this code from implement ECM after troubleshooting.
1. Check solenoid.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect lower anti-drift
solenoid from wiring harness (WP
0219 00).
(c) Turn engine start switch to ON
position (TM 5-3805-291-10).
(d) Place direction lever in NEUTRAL
position.
(e) At wiring harness connector for
1. If voltage is approximately 5 DCV,
solenoid, measure voltage from
replace solenoid (WP 0218 00).
implement ECM between contact 1 2. If voltage is approximately battery
(wire P945-OR) and contact 2 (wire
voltage, go to Test 2.
R799-BR).