TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Solenoid valve from previous test
2326 06 - Continued.
remains disconnected.
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is less than 5,000 Ohms,
implement ECM, measure
replace wiring harness in question (WP
resistance between contact for
0195 00 thru WP 0201 00).
failed solenoid circuit J1-61 (wire 2. If resistance is greater than 5,000 Ohms
P945-OR) and contact J2-8 (ground
(no continuity), exit this procedure and
wire R799-BR).
perform this troubleshooting procedure
again. Also, recheck if diagnostic code
indicator is active for this diagnostic
code. If cause is not found, replace
implement ECM (WP 0060 00).
427-C1673
N OT E
2328 03
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected.
Ensure diagnostic code indicator is active and that diagnostic code is active.
This test causes implement ECM to logan open circuit diagnostic code for this
solenoid. Clear this code from implement ECM after troubleshooting.
1. Check solenoid.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
